Table of Contents
Advertisement
Break-In Period
Only 8 hours of operating time is required for the break-in
period.
Since the first hours of operation are critical to future
dependability of the machine, monitor its functions and
performance closely so that minor difficulties, which could
lead to major problems, are noted and can be corrected.
Inspect the machine frequently during break-in for signs of
oil leakage, loose fasteners, or any other malfunction.
Operating Characteristics
Practice driving the machine because its operating
characteristics are different than some utility vehicles. Two
points to consider when operating the vehicle are
transmission and engine speed.
To maintain somewhat constant engine RPM, depress the
traction pedal slowly. This allows the engine to keep up
with the ground speed of the vehicle. By contrast, pushing
down quickly on the traction pedal will reduce engine RPM
and, as a result, there will not be enough torque-power to
move the vehicle. Therefore, to transfer maximum power to
the rear wheels, move the throttle to Fast and slightly
depress the traction pedal. By comparison, maximum
ground speed with no load results when the throttle is in the
Fast position and the traction pedal is slowly but fully
depressed. In summary, always keep the engine RPM high
enough to deliver maximum torque-power to the rear
wheels.
Caution
Operating the machine demands attention to
prevent tipping or loss of control.
• Use care when entering and leaving sand traps.
• Use extreme caution around ditches, creeks, or
other hazards.
• Use caution when operating the machine on a
steep slope.
• Reduce your speed when making sharp turns or
when turning on hillsides.
• Avoid sudden stops and starts.
• Do not go from reverse to full forward without
first coming to a complete stop.
Inspecting and Cleaning the
Machine
At the completion of operation, thoroughly wash the
machine with a garden hose—without a nozzle—so that
excessive water pressure will not cause contamination and
damage to the seals and bearings.
Make sure that the cooling fins and area around the engine
cooling air intake are kept free of debris. After cleaning,
inspect the machine for possible hydraulic fluid leaks,
damage, or wear to hydraulic and mechanical components.
17
Advertisement
Table of Contents
