Table of Contents
Advertisement
Replacing the Fuel Filter
An inline filter is incorporated into the fuel line. Change
the filter every 800 hours. Use the following procedures
when replacement becomes necessary:
1. Close the fuel shutoff valve.
2. Clamp both fuel lines that connect to the fuel filter
(Fig. 25) so that gasoline cannot drain when the lines
are removed.
3. Loosen the hose clamps at both ends of the filter and
pull the fuel lines off of the filter.
2
Figure 25
1. Fuel filter
4. Slide the hose clamps onto the ends of the fuel lines.
Push the fuel lines onto the fuel filter and secure them
with the hose clamps. Be sure that the arrow on the side
of the filter points toward the carburetor.
Adjusting the Traction Drive for
Neutral
If the machine moves when the traction pedal is in the
neutral position, the traction cam must be adjusted.
1. Park the machine on a level surface and turn the engine
off.
2. Pivot the seat upward and remove the engine shield.
3. Raise one rear wheel off of the floor and place support
blocks under the frame.
4. Loosen the locknut on the traction adjustment cam
(Fig. 26).
1
2. Hose clamps
24
1
Figure 26
1. Traction adjustment cam
Warning
The engine must be running so that the final
adjustment of the traction adjustment cam can be
performed. Contact with moving parts or hot
surfaces may cause personal injury.
Keep hands, feet, face, and other body parts away
from rotating parts, the muffler, and other hot
surfaces.
5. Start the engine and rotate the cam hex (Fig. 26) in both
directions to determine the mid position of the neutral
span.
6. Tighten the locknut securing the adjustment.
7. Stop the engine.
8. Install the engine shield and lower the seat.
9. Remove the jack stands and lower the machine to the
shop floor. Test drive the machine to make sure that it
does not move when the traction pedal is in neutral.
Adjusting the Traction Interlock
Switch
1. Adjust the transmission for neutral; refer to Adjusting
the Traction Drive for Neutral, page 24.
2. Activate the pump lever to ensure that all parts are
operating freely and seated properly.
3. Rotate the switch adjusting screw until there is a gap
between the head of the screw and the switch button.
4. Rotate the adjusting screw until it contacts the switch
button. Continue to rotate the screw until the circuit is
completed (the switch clicks). After the switch clicks,
rotate the adjusting screw an additional 1/2 turn.
5. Check for proper operation.
2
2. Locknut
Advertisement
Table of Contents
