Replacing The Hydraulic Pump-Drive Belt - Toro 74142TE Operator's Manual

10. Remove the existing belt.
11. Install the new belt around the mower pulleys and the
clutch pulley under the engine
Figure 61
1. Clutch pulley
2. Mower belt
3. Spring-loaded idler pulley
4. Ratchet
12. Install the belt guide on the idler arm shown in
61.
13. Using the ratchet in the square hole, install the idler
spring (Figure 61).
Make sure the spring ends are seated in the anchor
grooves.
14. Install the belt covers
(Figure 61).
5. Square hole in the idler
arm for the ratchet
6. Idler grease zerk
7. Belt guide
(Figure 62).
1. Position the belt cover
2. Slide belt cover under the
side catches
15. Install the sheet-metal guard. Refer to
Sheet-Metal Guard (page
16. Tighten the bolt for the mower-deck curtain. Refer to
Releasing the Mower-Deck Curtain (page
Replacing the Hydraulic
Pump-Drive Belt
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the mower belt. Refer to
Belt (page
Figure
4. Raise the machine and support it with jack stands
(Figure
5. Remove the clutch stop shown in
1. Clutch stop
6. Remove the idler spring from the post
44
Figure 62
3. Install the bolt
30).
43).
64).
Figure 63
Removing the
30).
Replacing the Mower
Figure 63.
1
g017494
(Figure 64).