Operating the Throttle
The throttle control can be moved between Fast and Slow
positions
(Figure
13).
Always use the fast position when turning on the mower deck
with the blade-control switch (PTO).
Operating the Choke
Use the choke to start a cold engine.
1. If the engine is cold, use the choke to start the engine.
2. Pull up on the choke knob to engage the choke before
using the ignition switch
3. Push down on the choke to disengage the choke after
the engine has started
1
2
1. On
Operating the Ignition Switch
1. Turn the ignition key to the Start position
When the engines starts, release the key.
G008946
Figure 13
(Figure
14).
(Figure
14).
G008959
Figure 14
2. Off
(Figure
Important: Do not engage starter for more than 5
seconds at a time. If the engine fails to start allow
a 15 second cool-down period between attempts.
Failure to follow these instructions can burn out
the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the fuel
system has been without fuel completely.
2. Turn the ignition key to the stop position to stop the
engine.
15).
18
G008947
Figure 15