Adjusting The Tracking; Checking The Tire Pressure - Toro 74142TE Operator's Manual

1. ROPS knob (locked
position)
2. Pull ROPS knob out and
rotate 90 degrees to
change roll bar position

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the motion-control
levers to the neutral-locked position.
3. Move the throttle midway between fast and slow.
4. Move both motion-control levers all the way forward
until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
6. If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until the
machine tracks straight
7. If it tracks to the left, loosen the bolts and adjust the
right stop plate rearward on the right T-slot until the
machine tracks straight
Figure 54
3. Roll bar in the upright
position
4. Roll bar in the folded
position
(Figure 55).
(Figure 55).
8. Tighten the stop plate
Left control lever shown
1. Control lever
2. Bolt

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the front and rear tires at 90 kPa
(13 psi). Uneven tire pressure can cause uneven cut. Check
the tires when they are cold to get the most accurate pressure
reading.
41
(Figure 55).
Figure 55
3. Stop plate
Figure 56