Using The Z Stand - Toro 74142TE Operator's Manual

6
Figure 31
1. Full-width ramp in stowed
position
2. Side view of full-width
ramp in loading position
3. Not greater than
15 degrees
1
2
5
4. Ramp is at least four times
(4X) as long as the height
of the trailer or truck bed
to the ground
5. H= height of the trailer or
truck bed to the ground
6. Trailer
Using the Z Stand®
The Z Stand® raises the front end of the machine to allow
you to clean the mower and remove the blades.
WARNING
The machine could fall onto someone and cause
serious injury or death.
• Use extreme caution when operating the
machine on the Z Stand®.
• Use only for cleaning the mower and removing
the blades.
• Do not keep the machine on the Z Stand for
extended periods of time.
• Always turn the engine off, set the parking
brake, and remove the key before performing
any maintenance to the mower.
Driving up onto the Z Stand
Important: Use the Z Stand on a level surface.
1. Raise the mower to the transport position.
2. Remove the bracket pin
g027996
1. Z Stand
2. Bracket pin
3. Bracket
3. Raise the latch. Swing the stand foot out front and
slide stand toward machine, into the bottom of slot
(Figure 32
26
(Figure 32).
Figure 32
4. Bottom of slot
5. Latch
and Figure 33).