Installing The Discharge Chute And Bag - Toro 62925 Operator's Manual

2. Secure the bag support to the inside of the lower
handle while mounting the handle (Fig. 2).
3. Secure starter rope guide to the lower handle with a
bolt and locknut (Fig. 3).
3
1
Figure 3
1. Bolt
2. Locknut
4. Pull the starter rope through the guide (Fig. 3).
5. Hook the lower end (ball end) of the traction control
wire in the keyhole slot in the arm on the traction drive
guard (Fig. 4).
1
3
Figure 4
1. Traction control wire
2. Traction drive guard
6. Secure the ball in the keyhole slot with a bolt and nut
(Fig. 4).
Note: Make sure ball end of cable is not between screw
head and drive guard.
7. Secure the lower end of the height control rod to the
bracket on the front wheel support with a hairpin cotter
(Fig. 5).
2
1824
3. Pull rope through rope
guide
2
3. Bolt and nut
2
1
3
Figure 5
1. Height control rod
2. Front wheel support
bracket
8. Secure the upper end of the height control rod to the
height adjustment handle with a hairpin cotter (Fig. 6).
Figure 6
1. Height control rod
2. Height adjustment handle
Installing the Discharge Chute
and Bag
1. Install the discharge chute and secure it with a bolt
(1/4 in.) and lock washer (Fig. 7).
1
2
Figure 7
1. Chute
7
1823
3. Hairpin cotter
3
2
1
1825
3. Hairpin cotter
1817
2. Bolt (1/4 in.) and lock
washer