Toro 62925 Operator's Manual page 17

2
Figure 25
1. Nut
3. Tighten the nut just enough so the belt does not slip;
do not over-tighten it.
Note: When you can no longer adjust a pulley, use the
other pulley. When the adjustment is used up on both
pulleys, replace the belt.
Replacing the Drive Belt
1. Stop the engine and pull the wire off of the spark plug.
2. Drain the gasoline from fuel tank; refer to Emptying
the Fuel Tank, page 15.
3. Drain the oil from crankcase; refer to Changing
Engine Oil, page 14.
4. Cut the old belt and remove it (Fig. 25).
5. Loosen the adjustment nuts on the belt tightener
pulleys (Fig. 25).
6. Remove the front snout (Fig. 15).
7. Slip the bag off of the chute and remove the chute
(Fig. 15).
8. Loosen the two locknuts securing the blower housing
to the stabilizer bracket (Fig. 26).
1
1826
2. Pulleys
17
Figure 26
1. Locknuts
2. Stabilizer bracket
9. Remove the bolt securing the blower housing and lift
the housing as much as the impeller allows (Fig. 26).
10. Route the new belt around the blower housing
(Fig. 27).
3
1
2
m–5460
3. Bolt