Toro 62925 Operator's Manual page 12

3. Remove the bag neck from blower discharge chute
(Fig. 15). (You may remove the entire bag if desired.)
4. Remove the retaining bolt and lock washer securing
the blower discharge chute and remove the chute
(Fig. 15).
5. Install the blower tube, securing it with the fasteners
removed in step 4 (Fig. 15).
6. Remove bolt securing blower housing to engine
bracket (Fig. 16).
Figure 16
Housing in Vacuum Position
1. Bolt
2. Housing
3. Engine bracket
7. Remove the 2 locknuts securing housing to engine
bracket and remove the bracket (Fig. 16).
8. Install the 2 locknuts on the housing mounting studs
for safe keeping.
9. Remove the 2 locknuts securing housing to stabilizer
bracket (Fig. 16).
10. Lift blower housing slightly and rotate it 120
clockwise (as you face the blower) (Fig. 15).
1
3
4
2
5
6
m–5460
4. Locknuts and housing
mounting studs
5. Locknuts
6. Stabilizer bracket
12
11. Reseat the housing, nesting the lower blower housing
mounting bracket onto the front edge of the engine
base (Fig. 17).
12. Install engine bracket on the housing mounting studs
with 2 locknuts (Fig. 17).
Figure 17
Housing in Blower Position
1. Lower blower housing
mounting bracket
2. Front edge of engine base
3. Bolt
13. Secure the bracket to the engine bracket with the bolt
removed previously (Fig. 17).
14. Install the blower intake screen, securing it with the
washer and locknut removed in step 2 (Fig. 15).
Caution
The air stream comes out of the blower in excess
of 100 mph (160 km/h)and can cause bodily injury
or property damage.
Ensure that the air stream is not aimed directly at
anybody or anything.
3
4
5
1
m–5470
2
4. Engine bracket
5. Locknuts and housing
mounting studs