Grounding Instructions; Installing The Vacuum Handle; Installing The Vacuum Bag - Toro POWERVAC 51984 Operator's Manual

Grounding instructions

See Figure 4.
A grounding wire is provided to help prevent static shock
when using the vacuum in low humidity conditions.

Installing the Vacuum Handle

See Figure 4.
1. Connect one end of the grounding wire to the ground-
ing tab located beneath the recoil housing.
2. Connect the other end of the grounding wire to one of
the vacuum handle knob posts.
3. Insert vacuum handle into the base of main housing.
4. Secure vacuum handle in place using vacuum handle
knobs.
Recoil
Housing
Upper
Handle
Vacuum
Handle
12

Installing the Vacuum Bag

See Figures 5 - 6.
1. Remove the sweeper nozzle and upper blower tube
from the main housing by twisting and removing from
main housing outlet.
Grounding
Tab
Vacuum Bag
2. Unzip the vacuum bag and place the adaptor inside
as shown. Push the vacuum bag adaptor through the
opening opposite the zipper. The wider end of the adap-
tor will remain on the inside of the vacuum bag when
installed properly.
Grounding
Wire
Adaptor Installed
in Vacuum Bag
Vacuum
Handle
Knobs
Figure 4
3. Align the raised slots on the vacuum bag adaptor with
the raised locking tabs on the main housing outlet; push
the bag adaptor onto the housing. Twist to lock into
place.
4. Rotate the vacuum bag until the shoulder strap is up-
right.
5. Make sure the vacuum bag is zipped and closed before
starting the unit.
Adaptor
Figure 5
Main
Housing
Outlet
Raised
Slot
Raised
Locking
Tab
Figure 6
Assembly