Driving The Machine Forward; Emptying The Debris Bag; Using The Bag Vent; Converting From Vacuum To Blower - Toro 62925 Operator's Manual

Driving the Machine Forward

Hold the traction control lever (Fig. 13) against the handle
to move forward. Release the traction control lever to stop
forward motion.
1
Figure 13
1. Traction control lever (disengaged)

Emptying the Debris Bag

When the debris bag is full, empty it as follows:
Note: You do not need to remove the bag to empty it.
1. Drive to the location where you want to dump the
debris.
2. Stop the engine.
3. Unzip the side of the bag and dump the contents
(Fig. 14).
Figure 14
1. Zipper for emptying
1819
2
1
1820
2. Bag vent
11
4. Close the zipper before starting the engine.
Warning
A worn debris bag could allow small stones and
other similar debris to be thrown in the operator's
or bystander's direction and result in serious
personal injury or death to the operator or
bystanders.
Check the debris bag frequently. If it is damaged,
install a new Toro replacement bag.

Using the Bag Vent

The bag has a zippered vent (Fig. 14). When vacuuming
an area which is basically free of dust, open the side vent
should be open to allow free movement of air. When
vacuuming a dusty area, close the vent.
Important
Keep the inside of the bag clean to allow
the air to circulate properly.
Converting from Vacuum to
Blower
1. Stop the engine.
2. Remove the locknut and washer securing the snout and
remove the snout (Fig. 15).
5
1
Figure 15
1. Snout
2. Bag neck
3. Blower discharge chute
2
3
4
1797
4. Blower tube
5. Blower intake screen