Storage - Toro 62925 Operator's Manual

Figure 27
1. Belt around housing
11. Insert the belt over the pulley and down through the
opening (Fig. 28).
Figure 28
1. Housing
12. Install and secure the blower housing with the bolt
removed previously and tighten the two nuts you
loosened.
13. Tip the unit back onto the handles.
14. Remove the cotter pin from the end of the traction
drive shaft, loosen the set screw in each of the collars,
and tap the shaft to the left far enough so the new belt
can be installed (Fig. 29).
1
1827
1
2
m-5469
2. Feed belt down through
opening
18
2
5
Figure 29
1. Cotter pin
2. Set screws
3. Shaft
15. Install the belt around the drive shaft pulley (Fig. 29).
Important The belt must be installed as shown in
Figure 29 or the traction drive will run backward.
16. Return the shaft to its original position, secure the
collars with the set screws, and the shaft with the
cotter pin (Fig. 29).
17. Ensure that the sprockets are aligned properly
(Fig. 29).
18. Adjust the belt; refer to Adjusting the Drive Belt,
page 16.

Storage

Storing the Machine
1. Stop the engine and remove the wire from the spark
plug.
2. Remove dirt and grime from the external parts of the
entire machine, especially the engine. Clean dirt and
chaff from the outside of the engine cooling system.
Important Do not pressure wash the engine.
3. Service the air cleaner; refer to Servicing the Air
Cleaner, page 13.
4. Lubricate the machine; refer to Lubricating the
Machine, page 15.
5. Change the oil; refer to Changing Engine Oil, page 14.
6. Remove and check the spark plug; refer to Servicing
the Spark Plug, page 15.
4
2
3
1
1826
4. Belt
5. Sprockets