Assembly
Loose Parts
Note: Use the chart below to verify all parts have been shipped with unit.
Description
Upper handle assembly
Bag support
Hex head bolt, 5/16 x 1-1/2 in.
Locknut, 5/15 in.
Hex head bolt, 1/4 x 1-13/4 in.
Locknut, 1/4 in.
Rope guide
Hex head bolt, 1/4 x 3/4 in.
Locknut, 1/4 in.
Height control rod
Hair pin cotter
Hex head bolt, 1/4 x 3/4 in.
Lock washer, 1/4 in.
Debris bag
Blower tube
Blower intake screen
Note: The machine is partially assembled as a lawn
vacuum. The blower intake and blower exhaust are not
used with the vacuum. To set the machine up as a blower,
refer to Converting from Vacuum to Blower, page 11.
Installing the Upper Handle
and Controls
1. Attach the upper handle to the lower handle with four
capscrews and locknuts (Fig. 2).
Qty.
1
1
Install upper handle
Install upper handle
4
4
1
1
Install rope guide
g
1
1
Install traction control wire
Install traction control wire
1
1
Install height control rod
Install height control rod
2
1
1
Install discharge chute
g
1
1
Install blower attachment
Install blower attachment
1
1. Lower handle
2. Upper handle
6
Use
1
2
4
3
1789
Figure 2
3. Bag support
4. Rope guide