Cutting Units (Enable Position); Adjusting The Travel Of The Front Three Cutting Units - Toro 03806 Operator's Manual

as required. Tighten set screw securing
adjustment.
Rear Cutting Unit
5. Locate valve in front of rear axle for rear
cutting units (Figure 76).
Figure 76
1. Adjustment valve for rear
cutting unit
6. Loosen locking ring securing knob (Figure 76).
7. Rotate valve clockwise to slow down drop rate
of rear cutting units.
8. Verify the lift rate adjustment by raising and
lowering cutting units several times. Readjust
as required. Tighten locking ring securing
adjustment.
Wing Cutting Units
9. Locate valves under seat for adjusting wing
cutting units (Figure 74).
10. Loosen set screws securing knob.
11. Rotate appropriate valve clockwise to slow
down drop rate of cutting units.
12. Verify the lift rate adjustment by raising and
lowering cutting units several times. Readjust
as required. Tighten set screw securing
adjustment.
Lifted Height of Outer
Front Cutting Units (Enable
Position)
The turnaround height of the front outer cutting
units (#4 & #5) and rear (#6 & #7) cutting units
2. Locking pin
may be increased to provide additional ground
clearance on contoured fairways.
Note: The RM CONFIG time delay should not
be changed from the original setting of 0 when
using this method to adjust turn around height.
To increase/adjust the turn around height of the
cutting units proceed as follows:
• Position machine on a level surface, lower the
cutting units and stop the engine.
• Loosen the carriage bolt nut securing the lift
arm switch bracket to the #4, 6 or 7 lift arms
(Figure 77). #4 shown in figure.
Figure 77
1. Lift arm switch
2. Carriage bolt nut
• Move the lift switch bracket up in the slot to
the desired position.
• Set the distance between the lift arm switch
and the flag on the lift arm to approximately
.062 inches.
• Tighten carriage bolt nut.
Adjusting the Travel of the
Front Three Cutting Units
Additional downward travel of the front three
cutting units may be desirable in highly contoured
locations. If any of the front three cutting units
lift off the ground when cresting a hill, the
front carrier frame may be lowered by removing
mounting bolts and repositioning frame in the
bottom set of holes in the main frame (Figure 78).
Contact your distributor for assistance.
51
3. Lift arm ag