Controlling The Position Of The Individual Cutting Units; Using The Cutting Unit Auto-Limited Lift In Reverse - Toro 30659 LT-F3000 Operator's Manual

Controlling the Position of the
Individual Cutting Units
The cutting units may be raised or lowered independently
using the bank of 3 lift-control switches.
1. To lower the cutting units, operate the lift-control
switches in a downward direction and release.
Note: The cutting-unit-drive switch must be on to do
this, the flail rotor drive engages when the cutting units
are approximately 150 mm (6 inches) above ground
level. The cutting units are now in 'float' mode and
follow the ground contours.
1. Lift-control switches
2. To raise the cutting units, operate the lift-control
switches in an upward direction and hold in position
3. If the cutting-unit-drive switch is in the O
the flail rotor drive disengages.
3. Release the lift-control switches when the cutting units
are at the required height.
Note: The control switches automatically return to
position 2 (N
EUTRAL
locked into position.
To raise the cutting units to the limited lift position:
momentarily operate the switches in an upward direction.
The flail rotor drive disengages immediately and the cutting
units stop raising, approximately 150 mm (6 inches) above
ground level.
This operates with the cutting units lowered and rotating.
Auto limited lift in reverse causes the cutting units to rise
automatically to the limited lift position when reversing. They
return to the floating position when returning to forward
travel. The flail rotors continue to rotate during this operation.
Figure 37
) and the arms are hydraulically
Using the Cutting Unit
Auto-Limited Lift in Reverse
To activate, press the auto-limited-lift switch to the O
position (Figure
To deactivate, press the auto-limited-lift switch to the O
position (Figure
Manual limited lift using the 3 lift-control switches is always
available regardless of the position of the auto switch.
position
N
28
38).
38).
Figure 38
N
FF