Toro 03806 Operator's Manual page 20

Figure 12
1. Hour meter
Backlap Knobs
The backlap knobs (Figure 13) are used in
conjunction with lower mow/raise control lever
for backlapping operation. Refer to Backlapping
in Cutting Unit Maintenance, page 48.
Figure 13
1. Reel control knobs
Reel Speed Controls
Controls RPM of front and rear cutting units
(Figure 13). #1 position is for backlapping.
Remaining settings are for mowing operations. See
decal under seat for proper settings.
Seat
The seat adjusting lever (Figure 14) allows 4 inch
fore and aft adjustment. The seat adjusting knob
(Figure 14) adjusts seat for operators weight. To
adjust seat fore and aft, pull lever on left side
of seat assembly outward. After moving seat to
2. Backlap knobs
desired location, release lever to lock seat into
position. To adjust for operators weight, turn
spring tension knob; clockwise to increase tension,
counterclockwise to decrease spring tension.
Figure 14
1. Seat adjusting lever
Green Diagnostic Light
The machine is equipped with a diagnostic light
which indicates if the electronic controller is
functioning correctly. The green diagnostic light
(Figure 15) is located under the control panel,
next to the fuse block. When the electronic
controller is functioning correctly and the key
switch is moved to the ON position, the controller
diagnostic light will be illuminated. The light will
blink if the controller detects a malfunction in the
electrical system. The light will stop blinking and
automatically reset when the key switch is turned
to the OFF position.
Figure 15
1. Green diagnostic light
When the controller diagnostic light blinks, one of
the following problems has been detected by the
controller:
20
2. Seat adjusting knob