Setup; Checking Fluid Levels; Installing The Cutting Units - Toro 03806 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
No parts required
Large O-ring
2
Counter weight
Steering locking pin
3
No parts required
Calcium chloride (obtain
separately)
4
Rear weight kit, part number
104–1478 (obtain separately)
CE decals
5
CE certicate
Operator's Manual
Engine Operator's Manual
Parts Catalog
Diagnostic ACE display overlay
6
Ignition keys on ring
Hood lock key
Gauge bar
Screw
Wing nut
Step
1

Checking Fluid Levels

No Parts Required
Procedure
Before starting the engine for the first time, check
the following fluid levels:
• Engine oil
Refer to Checking the Engine Oil in Operation,
page 22.
• Engine coolant
Refer to Checking the Cooling System
Operation, page 22.
Description
• Hydraulic oil
• Rear axle lubricant
13
Qty.
–
Check uid levels.
14/10
7/5 Install the cutting units.
7/5
Make cutting unit adjustments if
–
needed.
100lb
Add rear ballast (if required).
1
4
Install the CE decals.
2
1
1
1
1
Read the manuals and watch
1 the video before operating the
machine.
1
1
2
2
Refer to Checking the Hydraulic Oil in
Operation, page 22.
Refer to Checking the Rear Axle Lubricant in
Drive System Maintenance, page 41.
Use