Table Of Contents; Introduction - Toro 03806 Operator's Manual

Warning
CALIFORNIA
Proposition 65 Warning
Diesel engine exhaust and some of its
constituents are known to the State of
California to cause cancer, birth defects, and
other reproductive harm.
Important: This engine is not equipped
with a spark arrester muffler. It is a
violation of California Public Resource Code
Section 4442 to use or operate the engine
on any forest-covered, brush-covered, or
grass-covered land. Other states or federal
areas may have similar laws.

Introduction

Read this information carefully to learn how to
operate and maintain your product properly and
to avoid injury and product damage. You are
responsible for operating the product properly
and safely.
You may contact Toro directly at www.Toro.com
for product and accessory information, help
finding a dealer, or to register your product.
Whenever you need service, genuine Toro parts,
or additional information, contact an Authorized
Service Dealer or Toro Customer Service and have
the model and serial numbers of your product
ready. Figure 1 identifies the location of the model
and serial numbers on the product. Write the
numbers in the space provided.
Figure 1
1. Location of the model and serial numbers
© 2005-The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert
symbol (Figure 2), which signals a hazard that may
cause serious injury or death if you do not follow
the recommended precautions.
Figure 2
1. Safety alert symbol.
This manual uses two other words to highlight
information. Important calls attention to special
mechanical information and Note emphasizes
general information worthy of special attention.
Contents
Introduction ....................................................... 2
Safety .................................................................. 4
Safe Operating Practices ...................... 4
Toro Mower Safety .............................. 5
Sound Pressure Level........................... 6
Vibration Level.................................... 6
Safety and Instructional Decals ............ 7
Setup ................................................................ 13
1 Checking Fluid Levels ..................... 13
2 Installing the Cutting Units.............. 13
3 Making Alternate Cutting Unit
Adjustments...................... 15
4 Adding Rear Ballast......................... 16
5 Installing CE Decals........................ 16
6 Reading the Manuals and Storing
Additional Parts................. 16
Product Overview ............................................. 17
Controls ........................................... 17
Specifications ................................... 21
Operation.......................................................... 22
Checking the Engine Oil .................... 22
Checking the Cooling System............. 22
Filling the Fuel Tank .......................... 23
Checking the Hydraulic Fluid ............. 24
Checking the Tire Pressure................. 25
Checking the Reel to Bedknife
Contact ............................. 25
2
Contact us at www.Toro.com.
Printed in the USA.
All Rights Reserved