Reverse Side of Paper is Smudged
Have you loaded paper that is smaller than the size of the print data?
●
Check to make sure that the paper size matches the size of the print data.
Have you cleaned the fixing unit?
●
Clean the fixing unit.
Fixing Unit(P. 791)
Printed Barcode Cannot Be Read
Are you using a small barcode or a barcode consisting of thick lines?
●
Enlarge the barcode.
●
If the direction of lines in the barcode is perpendicular to the paper output direction, turn the image 90
degrees to make the lines parallel to the paper output direction.
●
If the problem persists even after performing the above operation, change the mode by using [Barcode
Adjustment Mode]. The improvement effect is weakest with [Mode 1] and strongest with [Mode 3]. Try the
adjustment starting with [Mode 1].
Setting in the Printer Driver
[Finishing] tab
Specifying Settings in the Setting Menu of the Operation Panel
Barcode Adjustment Mode(P. 681)
●
Print density will be lighter when you select stronger improvement.
●
When printing from the computer, the setting in the printer driver takes precedence. When the setting of
[Graphics Mode] in the printer driver is changed to [UFR II Mode] and [Barcode Adjustment Mode] is
changed to [Printer Default], the setting in the operation panel takes precedence.
Troubleshooting
[Advanced Settings]
[Barcode Adjustment Mode]
Select the mode
775