Configuring Settings For Device Management Software - Canon MF419x User Manual

Configuring Settings for Device Management Software

You can facilitate the collection and management of various information about networked devices by implementing
device management software, such as iW Management Console
settings, Address Books, and error logs is retrieved and distributed via the server computer. If the machine is
connected to such a network, iW Management Console searches the network for the machine by using protocols such
as Service Location Protocol (SLP) to gather information from the machine, such as power supply status information.
SLP settings can be specified via the Remote UI. This section also describes the procedure to configure settings for
communication between the machine and plug-ins for iW Management Console.
*
For more information about iW Management Console, contact your local authorized Canon dealer.
Configuring SLP Communication with Device Management Software(P. 513)
Configuring Settings for Communication between the Machine and Plug-ins(P. 516)
To use iW Management Console plug-ins
● You need to enable the settings of the dedicated port and the SNMP settings. As for the SNMP settings, set
[MIB Access Permission] to [Read/Write] for both SNMPv1 and SNMPv3.
Dedicated Port Settings(P. 639)
Monitoring and Controlling the Machine with SNMP(P. 508)
Configuring SLP Communication with Device Management Software
1
Start the Remote UI and log on in System Manager Mode.
UI(P. 606)
2
Click [Settings/Registration].
3
Click [Network Settings]
Network
*
, into the network. Information such as device
[TCP/IP Settings].
513
0UWX-08K
Starting Remote