Fuses - BOMBARDIER outlander 800 Operator's Manual

Remove the holding strap then pull the bat-
tery out of frame.
1. Battery
2. Holding strap
Cleaning
Clean battery, battery casing and battery
posts using a solution of baking soda and wa-
ter.
Remove corrosion from battery cable termi-
nals and battery posts using a firm wire brush.
Battery casing should be cleaned by soft
brush and baking soda solution.
Installation
Reinstall battery in vehicle.
WARNING
Connect RED (+) cable first then BLACK
(-) cable. Always connect RED (+) cable
first.
108

Fuses

If a fuse is damaged, replace it by one of the
same rating.
CAUTION: Do not use a higher rated fuse as
this can cause severe damage.
Fuses are located in the front service com-
partment, and at the rear near battery.
FRONT — FUSES LOCATION
1. (F1) Ignition coils (5 A)
2. (F2) Fan (20 A)
3. (F3) Fuel injectors (5 A)
4. (F4) Speedometer/speed sensor/tail
lamp (7.5 A)
5. (F5) Fuel pump (7.5 A)
6. (F6) Engine Control Module (ECM) (5 A)
7. (F7) Accessories (20 A)
REAR — FUSES LOCATION
1. (F8) Main (30 A)
(F9) Main accessories (30 A)