BOMBARDIER outlander 800 Operator's Manual page 70

Multi-Function Display Messages
MESSAGE
X 100 RPM
INVALID KEY
PARK BRAKE
LO BATT
HI BATT
LOW OIL (1)
HI TEMP (2)
LIMP HOME
CHECK ENGINE
MAINTENANCE SOON
NO ECM
COMMUNICATION
CAUTION: (1) If the light does not turn off right after engine starting, stop engine. Check engine
oil level. Refill if necessary. If the oil level is good, see an authorized Bombardier ATV dealer.
Do not use the vehicle until repaired.
CAUTION: (2) If the light does not turn off right after engine starting, stop engine. See an au-
thorized Bombardier ATV dealer. Do not use the vehicle until repaired.
68
When the speedometer is in RPM MODE, multi-function
display will show "X 100 RPM" if the Speed/RPM mode is
selected.
Indicates that you have used the wrong ignition key, use the
proper key for this vehicle. It is also possible that the ignition
key has a bad contact, remove and clean key.
Is displayed when parking brake is applied for more than 15
seconds (while riding).
Low battery voltage, check battery voltage and charging
system.
High battery voltage, check battery voltage and charging
system.
Engine low oil pressure, stop engine immediately and check
oil level.
Engine is overheating, refer to ENGINE OVERHEAT in
SPECIAL PROCEDURES.
Serious fault on the engine that can change the normal
operation of the engine, check engine indicator lamp will also
blink, refer to TROUBLESHOOTING for more details.
Engine fault, check engine indicator lamp will also be ON,
refer to TROUBLESHOOTING for more details.
Periodic maintenance required.
Communication error between speedometer and engine
control module (ECM), contact an authorized Bombardier
ATV dealer.
DESCRIPTION