Start Button; Engine Stop Switch - BOMBARDIER outlander 800 Operator's Manual

NOTE: Place ignition switch to ON "without
light" position to close the headlamp.
IGNITION SWITCH
1. OFF
2. ON "without light"
3. ON "with light"

Engine Stop Switch

Located at the middle of multi-function switch.
The engine will turn over but will not start if the
engine stop switch is turned to OFF position.
1
V07I05Y
TYPICAL
1. Engine stop switch
64
This switch can be used to stop engine and
as an emergency control.
NOTE: While engine can be stopped by turn-
ing ignition key OFF, we recommend the en-
gine be stopped by the engine stop switch.
To stop engine, fully release throttle lever then
use the engine stop switch.

Start Button

Located above engine stop switch.
2
V07I06Y
TYPICAL
1. Start button
2. Engine stop switch
To start engine, place the engine stop switch
to RUN.
Press and hold the start button. Release im-
mediately after engine is started.
1