Omron Programmable Terminals NT31 NT31C Setup Manual page 194

System Settings
184
Set the automatic reset function by following the menu operation from the Sys-
tem Menu shown below.
Ver 3.10
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press the
Quit touch switch. The settings made last will be set and the NT31/NT31C will
return to the MAINTENANCE MODE MENU screen.
• To quit the memory switch setting screen without confirming the settings, press
the Abort touch switch. The NT31/NT31C will return to the MAINTENANCE
MODE MENU screen with the previous settings still in effect.
Select Maintenance Mode.
Select Memory Switch.
Press [↓] (next screen) or [↑] (previous
screen) to display the third memory switch
setting screen.
Press Comm. Auto-return to display the re-
quired setting.
The setting option changes each time the
touch switch is pressed.
Section 6-9