Autolamps; Automatic High Beam Control - Ford EVEREST Owner's Manual

E211866
Move the lever up or down to switch on the
desired single side parking lamp.
High and Low Beam
Push the lever forward to switch between
high beam and low beam.
Headlamp Flasher
Slightly pull the lever toward you and
release it to flash the headlamps.

AUTOLAMPS

WARNING
The autolamps switch position may
not activate the headlamps in all low
visibility conditions, such as daytime
fog. Always ensure that your headlamps
are switched to auto or on, as appropriate,
during all low visibility conditions. Failure
to do so may result in a collision.
Everest (TEC) , EB3B-19G219-EKB enAUS, CPE Review
Lighting
E142451
When the lighting control is in the
autolamps position, the headlamps
automatically turn on in low light situations
or when the wipers activate.
The following also activate when the
lighting control is in the autolamps position
and you switch them on in the information
display:
• Configurable daytime running lamps.
•

Automatic high beam control.

The headlamps remain on for a period of
time after you switch the ignition off. Use
the information display controls to adjust
the period of time that the headlamps
remain on. See Information Displays
(page 72).
Note: With the headlamps in the
autolamps position, you cannot switch the
high beam headlamps on until the
autolamps system turns the low beam
headlamps on.
AUTOMATIC HIGH BEAM
CONTROL
The system does not relieve you of
your responsibility to drive with due
care and attention. A manual
override may be necessary if the system
fails to switch the high beam on or off.
52
WARNINGS