Duratorq-Tdci (148Kw/200Ps); Puma; Engine Oil Check; Engine Coolant Check - Ford EVEREST Owner's Manual

ENGINE OIL DIPSTICK - 2.2L
DURATORQ-TDCI (118KW/
160PS) - PUMA/3.2L
DURATORQ-TDCI (148KW/
200PS) - PUMA
A B
E71362
A MIN
B MAX

ENGINE OIL CHECK

1. Make sure that your vehicle is on level
ground.
2. Switch off the engine and wait 10
minutes for the oil to drain into the oil
pan.
3. Remove the dipstick and wipe it with
a clean, lint free cloth. Replace the
dipstick and remove it again to check
the oil level.
If the oil level is at the minimum mark, add
oil immediately. See Capacities and
Specifications (page 258).
Note: Check the oil level before starting the
engine.
Note: Make sure that the oil level is
between the minimum and the maximum
marks.
Note: Do not use oil additives or other
engine treatments. Under certain conditions,
they may damage the engine.
Everest (TEC) , EB3B-19G219-EKB enAUS, CPE Review
Maintenance
Note: The oil consumption of new engines
reaches its normal level after approximately
5,000 km.
Adding Oil
Only add oil when the engine is cold.
If the engine is hot, wait 10 minutes
for the engine to cool down. Failure
to take care may result in personal injury.
Do not remove the filler cap when
the engine is running. Failure to take
care may result in personal injury.
1. Remove the filler cap.
2. Add oil that meets Ford specifications.
See Capacities and Specifications
(page 258).
3. Replace the filler cap. Turn it until you
feel a strong resistance.
Note: Do not add oil further than the
maximum mark. Oil levels above the
maximum mark may cause engine damage.
Note: Soak up any spillage with an
absorbent cloth immediately.

ENGINE COOLANT CHECK

Do not dispose of engine coolant in
the household refuse or the public
sewage system. Use an authorized
waste disposal facility.
Do not put engine coolant in the
windshield washer fluid container. If
sprayed on the windshield, engine
coolant could make it difficult to see
through the windshield.
224
WARNINGS
WARNINGS