Changing The 12V Battery; Checking The Wiper Blades - Ford EVEREST Owner's Manual

A
E208053
A Front of Vehicle.
For item location: See Under Hood
Overview (page 220).
1. Switch the ignition off.
2. Attach a tube to the drain plug and
place the end of the tube into a
suitable container.
3. Loosen the drain plug approximately
1.5 turns.
4. Switch the ignition on to activate the
in-tank pump.
5. Allow the water to drain.
6. Switch the ignition off.
7. Tighten the drain plug until you feel a
strong resistance.
8. Remove the tube from the drain plug.
9. Start the engine.
10. Check for leaks.
Note: The water-in-fuel indicator lamp will
go out after approximately 2 seconds, with
the engine running.
Everest (TEC) , EB3B-19G219-EKB enAUS, CPE Review
Maintenance

CHANGING THE 12V BATTERY

For vehicles with start-stop the
battery requirement is different. You
must replace the battery with one of
exactly the same specification.
Note: Where applicable you must
reprogram the audio system using the
keycode.
The battery is located in the engine
compartment. See Maintenance (page
218).
CHECKING THE WIPER
BLADES
E222238
Run the tip of your fingers over the edge of
the blade to check for roughness.
Clean the wiper blades with isopropyl
alcohol or windscreen washer concentrate.
227
WARNING