Ford EVEREST Owner's Manual page 234

3. Turn the bulb holder counterclockwise
and remove it.
Note: You cannot separate the fog lamp
bulb from the bulb holder.
Replacing the Tail, Brake and Turn
Signal Lamp Bulbs
E206198
1. Make sure the headlamp control is in
OFF position and open the liftgate.
2. Remove the tail lamp cover starting
from the outboard edge using a flat tip
screw driver.
3. Remove the two bolts from the lamp
assembly.
4. Disconnect the electrical connector
and gently pull out the lamp assembly.
Everest (TEC) , EB3B-19G219-EKB enAUS, CPE Review
Maintenance
2
3
E206199
A Rear turn signal.
B Stop/Rear Position Lamp.
C Rear Position lamp.
1. Remove the bulb socket from the lamp
assembly by turning it
counterclockwise.
2. Remove the bulb by:
• Rear turn signal bulb - Gently
pushing it into the socket and
turning it counterclockwise.
• Stop/Rear Position Lamp- Gently
pushing it into the socket and
turning it counterclockwise.
• Rear position lamp- Gently pulling
the bulb from the socket.
Install the new bulbs in reverse order from
the steps above.
Note: If your vehicle is fitted with LED
Stop/Rear Position Lamps these are not
serviceable. Take your vehicle to an
authorized dealer if they fail.
Replacing a Reverse Lamp Bulb
1. Open the liftgate.
2. Remove the lift gate inner grab handle
cover using a standard flat tip screw
driver.
232
A B
C