6
CONTROLS
6.20
Closing filler cap
6.21
Idle speed adjusting screw
6.22
Shift lever
–
Press release button
remove.
M00150-10
–
Replace the filler cap and turn clockwise until the release button
place.
Info
Route the fuel tank breather hose
M00150-11
Idle speed adjusting screw
The idle speed adjusting screw has two functions.
Turning it controls the idle speed.
Pulling it out all the way raises the idle speed during a cold start.
Possible states
RPM increase activated – Idle speed adjusting screw is pulled out all the way.
•
RPM increase deactivated – Idle speed adjusting screw is pushed in all the way.
•
L02462-10
Shift lever
401950-10
, turn filler cap counterclockwise and lift it upwards and
is located at the top left of the throttle valve body.
is mounted on the left side of the engine.
without kinking.
18
locks in