Installing The Fork Legs - KTM 350 EXC-F Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.8

Installing the fork legs

Main work
(EXC‑F EU/AU/BR, XCF‑W)
–
Position the fork legs.
Bleeder screws
M00095-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
M00145-11
(EXC‑F Factory Edition)
–
Position the fork legs.
Bleeder screws
S00640-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
M00138-11
(All Six Days models)
–
Position the fork legs.
Bleeder screws
M00137-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
M00138-11

are positioned toward the front.
Info
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.

.

.

are positioned toward the front.
Info
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
 .

.

are positioned toward the front.
Info
The rebound damping is located in the right fork leg REB (red adjusting
screw). The compression damping is located in the left fork leg COMP
(white adjusting screw).
Grooves are milled into the side of the upper end of the fork legs. The
second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.

.

.
M8 20 Nm
(14.8 lbf ft)
M8 15 Nm
(11.1 lbf ft)
M8 17 Nm
(12.5 lbf ft)
M8 15 Nm
(11.1 lbf ft)
M8 17 Nm
(12.5 lbf ft)
M8 15 Nm
(11.1 lbf ft)
51