Liftgate Switch - Ford ENDEAVOUR Owner's Manual

Liftgate Switch

E129838
Switch the ignition on to operate
the liftgate using the center
console switch.
Note: A tone sounds three times when the
liftgate begins to close.
Five short tones indicate a malfunction
with the open or close request. This could
be caused by one of the following:
• You switch the ignition on and the
transmission selector lever is not in
park.
• The battery voltage is below the
minimum operating voltage.
• Your vehicle speed exceeds 3 mph (5
km/h).
To unlock a fully closed liftgate, you can
either:
• Press the button on the remote control
once.
• Press the center console switch.
To open a fully closed liftgate, you can
either:
• Press the button on the remote control
twice within three seconds.
• Press the center console switch.
• Use the liftgate switch.
Endeavour (TEC), EB3B-19G219-ZCA enIND
Doors and Locks
To fully open a partially opened liftgate,
you can either:
•
•
•
To stop the liftgate, you can either:
•
•
•
Closing the Liftgate
the vehicle body.
Note: Do not leave a passive key in your
vehicle when closing the liftgate. A message
will be shown in the display. See
Information Messages (page 78).
Note: A recessed grip is located inside the
liftgate to help with closing.
You can either:
•
•
•
•
39
Press the button on the remote control
twice within three seconds.
Press the center console switch or the
liftgate switch.
Use the liftgate switch.
Press the button on the remote control.
A further remote control operation will
be delayed for approximately three
seconds.
Press the center console switch or the
liftgate switch.
Use the liftgate switch.
WARNING
The bounce-back feature will not
work and it will not detect obstacles
when the liftgate is in contact with
Press the button on the remote control
twice within three seconds.
Press the center console switch or the
liftgate switch.
Use the liftgate release switch.
Manually close the liftgate