Doors And Locks; Locking And Unlocking; Power Door Locks; Autolock Configuration - Ford ENDEAVOUR Owner's Manual

LOCKING AND UNLOCKING

Power Door Locks

The power door lock control is on the driver
and front passenger door panels.
A
B
E184784
A Unlock.
B Lock.
Remote Control
You can use the remote control at any time
while your vehicle is switched off.
Unlocking the Doors
Press the button to unlock all
doors. The direction indicators
will flash.
Note: You can unlock the driver's door with
the key. Use the key when the remote
control is not functioning.
Note: When you leave your vehicle locked
for several weeks, the remote control will
be switched off. Your vehicle must be
unlocked with key and started. Unlocking
and starting your vehicle once will enable
the remote control.
Endeavour (TEC), EB3B-19G219-ZCA enIND

Doors and Locks

Reprogramming the Unlocking
Function
You can reprogram the unlocking function
so that only the driver door is unlocked.
See Remote Control (page 27).
Locking the Doors
E138623
Note: If any door or the luggage
compartment is not closed, or if the hood is
not closed on vehicles that have an
anti-theft alarm or remote start, the
direction indicators will not flash.

Autolock Configuration

You can configure autolock and
autounlock through the instrument cluster.
See Instrument Cluster (page 63).
Follow the process below if your
instrument cluster does not allow you to
configure autolock and autounlock.
Note: This operation has to be done within
30 seconds.
1.
2. Press door lock button three times.
3. Switch the ignition off.
4. Press door lock button three times.
5. Switch the ignition on.
6. Press door lock button two times.
A tone sounds twice to indicate that the
driver configuration mode is enabled.
Automatic locking by speed
Note: Automatic locking by speed is
disabled by default.
All the doors lock automatically when you
drive at or above 7 km/h.
35
Press the button to lock all the
doors. The direction indicators
will flash.
Switch the ignition on.