Brake And Clutch Fluid Check; Power Steering Fluid Check; Washer Fluid Check - Ford ENDEAVOUR Owner's Manual

Note: The cooling system filler cap should
be inspected and cleaned regularly. The cap
should be replaced if there is any evidence
of deterioration of the sealing.
BRAKE AND CLUTCH FLUID
CHECK
WARNINGS
Use of any fluid other than the
recommended brake fluid may
reduce brake efficiency and not meet
Ford's performance standards.
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your doctor.
Clean the filler cap before removing.
Use only fluid that meets Ford
specifications and from a sealed
container.
Note: Keep brake fluid clean and dry.
Contamination with dirt, water, petroleum
products or other materials may result in
brake system damage and possible failure.
Note: The brake and the clutch systems are
supplied from the same reservoir.
Note: Make sure that your vehicle is on level
ground.
The fluid level will drop slowly as the
brakes wear, and will rise when the brake
components are replaced.
Fluid levels between the MIN and MAX
lines are within the normal operating range;
there is no need to add fluid.
If the fluid levels are outside of the normal
operating range, the performance of the
system could be compromised; seek
service from you authorized dealer
immediately.
Endeavour (TEC), EB3B-19G219-ZCA enIND
Maintenance
Top up with fluid that meets the Ford
specification. See Capacities and
Specifications (page 227).
POWER STEERING FLUID
CHECK
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your physician.
Note: Make sure that the fluid level is
between the MIN and the MAX marks.
If the level is at the MIN mark, top up
immediately. See Capacities and
Specifications (page 227).
Adding Power Steering Fluid
Note: Make sure that your vehicle is on level
ground.
Note: Do not add fluid further than the MAX
mark.
1. Remove the filler cap.
2. Add fluid that meets Ford
specifications. See Capacities and
Specifications (page 227).
3. Replace the filler cap.

WASHER FLUID CHECK

Note: The reservoir supplies the front and
rear washer systems.
When adding fluid, use a mixture of washer
fluid and water to help prevent freezing in
cold weather and improve the cleaning
capability. We recommend that you use
only high quality washer fluid.
For information on fluid dilution, refer to
the product instructions.
193
WARNING