Heating System Start-Up - Buderus Logano GE434 Maintenance Instructions Manual

6

Heating system start-up

6 Heating system start-up
This chapter details how to properly commission the
heating system.
BOILER DAMAGE
through excessive dust and airborne seed.
! Do not operate the boiler where heavy
CAUTION!
dust contamination persists, e.g.
through building work inside the boiler
room.
! Ensure that incoming combustion air is
not contaminated with excessive dust
from dirt roads and paths or through
dusty production or processing
installations, e.g. quarries, mines, etc.
! Ensure that incoming combustion air is
not contaminated with excessive
airborne seed from composite
blossom. Where necessary, prevent
such contamination through the use of
air filters.
We reserve the right to make any changes due to technical modifications.
Commissioning and maintenance instructions Logano GE434 Gas-fired special boiler • Issue 02/2003
18
BOILER DAMAGE
through contaminated combustion air.
! Ensure adequate air supply.
CAUTION!
! Ensure that chlorinated cleaning
agents or halogenated hydrocarbons
(as, for example, contained in spray
cans, solvents or cleaning agents,
paints and adhesives) are not used or
stored in the boiler room.
! Clean burners contaminated through building work
before commissioning the heating system (see
Chapter 8.2 "Preparing the boiler for cleaning",
page 35 and following).
RISK TO LIFE
through toxic flue gases
! Ensure that, during the burner
WARNING!
operation, there is no mechanical air
handling equipment inside the boiler
room, which might withdraw
combustion air from the boiler room,
e.g. cooker hoods, dryers, ventilation
equipment.
PLEASE NOTE
To reach components which are vital for
commissioning, the central and read side
panels and the front panel must be
removed.
The bottom of the central and rear side
panels are secured with screws.
Buderus Heiztechnik GmbH • http://www.heiztechnik.buderus.de