Table of Contents
Advertisement
MAINTENANCE WORK ON FRAME AND ENGINE
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the
brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
–
Clean screw
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
200487-10
Guideline
Bolt, front axle
–
Position the brake calipers and check that the brake linings are seated correctly.
–
Mount screws
–
Operate the hand brake lever repeatedly until the brake lining presses up against the
brake disc and there is a pressure point. Fix the hand brake lever in the activated posi-
tion.
The brake calipers align themselves.
–
Tighten screws
Guideline
700271-12
Screw, front brake caliper
–
Release the fixation of the hand brake lever.
–
Take the front of the motorcycle off the work stand. (
–
Take the rear from the work stand. (
and axle
.
.
on both brake calipers but do not tighten yet.
on both brake calipers.
M10x1.25
p. 111)
M25x1.5
45 Nm
(33.2 lbf ft)
Loctite
®
45 Nm
(33.2 lbf ft)
p. 110)
155
243™
Advertisement
Table of Contents
