Backguard Installation - Thermador PRD30 Installation Manual

Dual fuel ranges
Hide thumbs Also See for PRD30:
Table of Contents

Advertisement

Available languages

Available languages

2. Mount the (2) top shelf brackets and the (3) lower shelf
brackets at the locations outlined on the templates.
Secure with (10) 1" (25.4mm) screws provided.
3. Cut template out from around the brackets and remove
from the wall. Do not discard template before the Keep
Hot Shelf is completely installed.
4. Insert (3) U-Nuts onto the (3) lower shelf brackets.
5. Install the wall plate by setting the corner notches
(back of wall plate) atop the (2) top shelf brackets.
Slide the shelf upwards until the bottom engages with
the (3) lower brackets on the 30" & 36" models and (4)
brackets for the 48" models (Figure 19).
Upper shelf bracket (x2)
6. Check if the top is properly secured by pulling the top
section of the shelf from the wall.
7. Secure to bottom of shelf with the (4) 1/2" (12.7mm)
screws provided.
For 48" Keep Hot Shelf
Follow steps 1-6 except use (4) lower brackets which must
be spaced equally 15" (381mm) center-to-center.

Backguard Installation

NOTE:
If a backsplash is to be used in addition to a backguard,
install the backsplash first and the backguard second
before sliding range into place.
WARNING:
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
English 20
Notches (x2)
Lower shelf bracket (x4)
Figure 19: 48" Back of Wall Plate
High Shelf Parts Included
High Shelf top panel
High Shelf front panel
T-20 Torx Stainless screws
T-20 Torx drill point screws
Installation Guide
Low Back Parts Included
Low Back panel
T-20 Torx stainless screws
T-20 Torx drill point screws
Installation Guide
Tools Needed
T-20 Torx head screwdriver or drill
Protective Work Gloves
WARNING:
Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid
potential laceration to finger or hand while sliding the
backguard down onto the range.
CAUTION:
The High Shelf can get very hot! DO NOT place the
following items on top of the High Shelf:
plastics or containers that can melt
flammable items
a total load over 30 pounds (13.6kg)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prd48Prd36

Table of Contents