Setup; Basic Setup - Samsung SNV-L6013R User Manual

setup screen

SeTup

On the network, you can set up basic information on the camera, video and audio, network events and system.
1. In the Live screen, click [ Setup ( ) ] .
2. The Setup screen appears.
The setting page for preview video requires the STW web viewer plug-in to be installed on the PC.
`
J
If it is not intalled properly, the installation page automatically apprears.

BASiC SeTup

video profile
1. From the Setup menu, select the <Basic (
2. Click <video profile>.
3. Set the <video profile connection policy>.
• Keep connection when profile setting is changed : Output
uses the same settings even when the settings of the
active profile are changed.
If not selected, changing a profile used by an existing
connection resets such connection.
4. Select each profile properties.
For more details, refer to "To Add/Change the video
profile". (Page 28)
5. Click the input box of each item and enter / select a desired
value.
The context menu may differ depending on the selected codec type.
`
• Default profile : If no profile is selected when using the Web
Viewer, the default video profile is applied.
• E-mail/FTP profile : Video profile to be transferred to the
specified email or FTP site.
Only the MJPEG codec can be set as the E-mail/FTP profile.
`
• Record profile : This is the profile that is applied to video
recording.
• Audio-In : Sets whether to use audio for video recordings.
)> tab.
6. According to your situation, set ATC (Auto Transmit Control) mode.
• ATC mode : It adjusts the video properties according to the
variance in the network bandwidth, controlling the bit rate.
Adjusting the bit rate depends on the ATC mode.
- Control framerate : Reduce the frame rate if the network
bandwidth drops down.
- Control compression : Control the compression rate if the network bandwidth drops down.
Compression adjustment can cause deterioration of the image quality.
- Event (MD) : This function works when a Motion Detection (MD) event is selected.
If an event occurs, the system controls the frame rate.
If no movement is detected, the system outputs signals at the minimum frame rate, thus reducing
use of the bandwidth.
If <Bitrate control> is set to <CBR>, the encoding priority according to the ATC mode will be fixed as below:
`
Bitrate control / ATC mode Control framerate
CBR Framerate
• ATC sensitivity : Affect the transfer rate according to the variance in the network bandwidth.
The transfer rate will be adjusted to the fastest if the bandwidth is <very high>, and adjusted to the
latest if the bandwidth is <very low>.
• ATC limit : If the quality or frame rate is adjusted, the property will be changed to the applied value (%)
against the previous setting value (100%).
Note that if you reduce the property value too much, you may encounter flickering on the screen. So it
is advisable to adjust the value within the threshold.
It is recommended to apply ATC control only for cameras supporting ATC.
`
J
Set the ATC sensitivity to <Very low> in a network environment with high variance in the network bandwidth.
`
If the network connection is unstable, you may encounter flickering on the screen.
`
7. When done, click [Apply ( )].
Control compression Event(MD)
Compression Framerate
English _27