Samsung SNV-L6013R User Manual page 32

setup screen
Audio setup (Snv-L6014rm)
You can configure the I/O settings of the audio source from the camera.
1. From the Setup menu, select the <video & Audio (
tab.
2. Click <Audio setup>.
3. Set the audio input value.
• Source : Sets the audio input.
- Line : Connect the cable to the audio device.
- Internal microphone : Microphone that is built-in in the
camera.
- External microphone : 3.5 pi(¢) jack type external MIC.
• Apply power to Ext. Mic. : If the external microphone connected has no separate power supply, check
this option to set camera to supply power to the connected external microphone. The option is enabled
if <external microphone> is selected.
• Codec : Specify the audio codec.
- G.711 : A audio codec standard, it uses 64 Kbps PCM (Pulse Code Modulation) encoding.
ITU standard audio codec that is adequate for digital voice transfer in PSTN network or through a
PBX.
- G.726 : ITU standard audio codec applying ADPCM (Adaptive Differential Pulse Code Modulation) for
variable bit rates of 40/32/24/16 Kbps to 64 Kbps PCM encoding.
• Bitrate : Set the bit rate to differentiate compression ratio if using G.726 codec.
• Gain : Specify the audio input amplification.
Sound quality deterioration or howling may occur if the loudness of the sound source or gain value were set excessively.
`
J
4. Set the audio output level.
• Enable : Sets whether to use audio output.
• Gain : Specify the audio output amplification.
5. When done, click [Apply ( )].
32_ setup screen
)>
Camera setup
You can change the camera settings according to the environment where the camera is located.
1. From the Setup menu, select the <video & Audio (
tab.
2. Click <Camera setup>.
3. Configure the settings as necessary of : Sensor, SSDR, White
balance, Back light, Exposure, Day/Night, Special, OSD, IR
4. When done, click [Apply ( )].
If a certain time (timeout: 240s) is elapsed with your not pressing the [Apply
`
( )] button after changing the settings, your changes will not be
applied.
To Set the Sensor
It specifies how many frames the camera CMOS sensor will capture per second.
1. Select <Sensor>.
2. Select <mode>.
Refer to "Video profile" for the framerate setup range of the <Video profile> according to mode setup. (Page 27)
`
M
To Set SSDr (Samsung Super Dynamic range)
In a scene where the difference between bright and dark is severe, you can increase the brightness of the
dark area alone to regulate the overall brightness.
1. Select <SSDr>.
2. Set <mode> to <on>.
3. Configure the <Level> and <D-range> settings as
necessary.
• Level : Adjust the level of the dynamic range.
• D-Range : Select the amplitude area of the dynamic range.
)>