Installation & Connection; Installation - Samsung SNV-L6013R User Manual

installation & connection

inSTALLATion

precautions before installation
Ensure you read out the following instructions before installing the camera:
• When installing on a ceiling, desired spot must be capable of supporting at least 5 times of the camera's
weight.
• Stuck-in or peeled-off cables can cause damage to the product or a fire.
• For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
• This camera (SNV-L6014RM) is compliance with the IP66 specifications and is a water proof product, however,
no waterproofing will be provided with the jack if you don't use the M12 connector and cables.
When you install this product, it is recommended to use an external cable that meets the M12 specification.
Disassembling
Using the L-wrench provided, loosen 3 screws by turning them
counterclockwise and separate the dome cover.
Note that it is not necessary to loosen the screw completely.
`
installing the camera on the ceiling
1. Select a location where you want to install the camera.
2. Prepare a hole for a screw on the wall where you are going to install the
device, then insert the plastic drywall anchor that has been provided all
the way into the hole.
3. Align the internal hole with the hole into which the plastic anchor has
been inserted, and turn the tapping screw clockwise to fasten it.
Use the enclosed installation bracket when installing the product on the wall.
`
M
4. Turn the screws on both sides of the camera lens cover
counterclockwise to loosen them.
Forcing to tile the lens (hood) without loosening the screws may cause a product
`
J
defect.
5. Adjust the lens in a desired direction by referring to the "Adjusting the
monitoring direction for the camera" section. (page 10)
6. After adjusting the angle, turn the screws clockwise to fix the lens angle.
7. Close the dome cover and turn it clockwise using the L-wrench.
If the cover is not fixed tightly, you may encounter a problem with
`
J
waterproofing. (IP66)
How to connect the rJ45 waterproof cable to a LAn cable (Snv-L6013r)
1. Insert it through the arrow direction.
2. Connect the LAN connector (male) to the cable.
3. Connect the RJ45 modular jack (female) to the RJ45 connector
(male).
Please, keep each of the parts separated.
Fixing Hole
`
J
Lens cover
0~67°
RJ45 connector
(male)
RJ45 modular
jack (female)
English _9