Error Indications; Error Codes - Brother DCP-1510 Service Manual

3. ERROR INDICATIONS

3.1

Error Codes

Errors in the shaded columns do not usually occur during normal use. The possible causes
are noise around the installation site, fluctuation of the power supply voltage, and failures in
the software.
Error
codes
0100
Cannot detect the synchronized
signal of the main motor.
0201 The speed of the main motor
does not stabilize within the
specified time.
0202
0203
0204
0205
0206
0207
0208
0209
Cannot detect the Lock signal
0300 from the document scanner
motor.
Cannot detect the synchronized
0401 signal of the polygon motor for
the laser unit.
0402
Refer
Problem
-
1-23
-
-
-
-
-
-
-
-
1-23
1-23
-
1-10
Error
to: codes
The center thermistor of the
fuser unit has not reached the
0501
specified temperature within the
specified time.
The center thermistor has not
reached the specified
0502 temperature within the specified
time after the fuser unit has
reached to a certain temperature.
The center thermistor of the
fuser unit detected a
0503
temperature higher than the
specified value.
After the heat unit was heated
normally, the center thermistor of
0504 the fuser unit detected a
temperature lower than the
specified value.
The center thermistor of the
fuser unit detected a
0505 temperature rise greater than the
specified value within the
specified time.
The center thermistor of the
fuser unit detected a
0506 temperature fall greater than the
specified value within the
specified time.
0507
0508
0509
The hardware detected that the
050A center thermistor of the fuser unit
indicated a temperature error.
050B
050C
Operated 100% heating for
050D longer than the specified time in
the fuser unit while printing.
Refer
Problem
1-24
1-24
1-24
1-24
1-24
1-24
-
-
-
1-25
-
-
1-25
Confidential
to: