Cis Unit / Cis Flat Cable - Brother DCP-1510 Service Manual

7.4.1

CIS unit / CIS flat cable

(1) Remove the two (four for models without ADF unit) taptite bind B M4x12 screws to remove
the scanner top cover ASSY from the document scanner unit.
(2) Remove the CIS roller holder L ASSY and the CIS roller holder R ASSY from the CIS unit.
(3) Open the CIS unit 130 degrees and slide it to the directions of the arrow 3a and 3b to
remove it from the CIS carriage ASSY.
(4) Disconnect the CIS flat cable from the CIS unit.
(5) Release the CIS flat cable from the securing fixtures, and remove it from the document
scanner unit.
Taptite bind B M4x12
(only for models without
ADF unit)
CIS roller holder R ASSY
CIS flat cable
ADF bevel
gear ASSY
CIS unit
CIS carriage ASSY
Harness routing: Refer to
Assembling Note:
• When removing the scanner top cover, ADF bevel gear ASSY will come off. When
assembling the scanner top cover, make sure that the ADF bevel gear ASSY is
assembled.
130°
3a
3b
Fig. 2-17
"4. Document scanner unit"
2-22
Taptite bind B M4x12
CIS flat cable
CIS roller holder L ASSY
Document scanner unit
and "5. Panel flat cable".
Scanner top
cover ASSY
Confidential