Brother DCP-1510 Service Manual page 54

Error code 8E02
Size mismatch
Reload correct paper, then press Start.
Detected that the size of paper set in the paper tray was over 10 mm shorter than letter size
during receiving fax or printing list/report.
<User Check>
• Select A4 or letter size in the paper setting.
Step
Paper printing position actuator
1 caught in sections of the
machine
Paper feed/paper printing
2
position sensor failure
3 Main PCB failure
Error code 9002
Size Mismatch
Reload correct paper, then press Start.
When printing from the paper tray, the size of paper set in the paper tray does not match the
size specified by the driver.
<User Check>
• Change the driver setting to match the size of the paper set in the paper tray.
Step
Paper printing position actuator
1 caught in sections of the
machine
Paper feed/paper printing
2
position sensor failure
3 Main PCB failure
Cause
Reattach the paper printing position actuator.
Replace the paper feed/paper printing position
sensor PCB ASSY.
Replace the main PCB ASSY.
Cause
Reattach the paper printing position actuator.
Replace the paper feed/paper printing position
sensor PCB ASSY.
Replace the main PCB ASSY.
1-37
Remedy
Remedy
Confidential