Transfer Received Fax Data / Log Information (Function Code: 53); Transfer Received Fax Data / Log Information - Brother DCP-1510 Service Manual

1.3.14 Transfer received fax data / log information (function code: 53)

<Function>
When the machine is unable to print the received fax data due to an error in the printing
mechanism, this function is used to transfer the data to another machine. The
communication management report, communication list, or machine log information can also
be transferred.
Note:
• The number of files that can be transferred in one operation is up to 99. When there are
100 or more files, the operating procedure below must be performed several times to
transfer all files.
• When there are both color data files and monochrome data files, monochrome data files
are transferred first. When the color function is not supported by the receiving machine,
color data files cannot be transferred and an error occurs.
<Operating Procedure>
(1) Press the [5] and [3] buttons in this order in the initial state of maintenance mode. "FAX
TRANSFER" is displayed on the LCD.
• To check the number of files received, press the [1] button. "1. NO. OF JOBS" is
displayed on the LCD. Press the [SET] button, and the number of files received is
displayed, for example, "NO. OF JOBS: 10".
• To transfer only the communication management report, press the [2] button.
"2. ACTIVITY" is displayed on the LCD.
• To transfer the received data, press the [3] button. (The communication management
report is also transferred.)
"3. DOCUMENTS" is displayed on the LCD. If there are no received files, "NO
DOCUMENTS" is displayed.
• To transfer the communication list (latest communication information), press the [4]
button. "4. COM.LIST (NEW)" is displayed.
• To transfer the communication list (information for the past three errors), press the [5]
button. "5. COM.LIST (ERR3)" is displayed on the LCD.
• To transfer the maintenance information (list printed by function code 77), press the
[6] button. "6. MNT77LIST" is displayed on the LCD.
(2) Press the [SET] button while "2. ACTIVITY", "3. DOCUMENTS", "4. COM.LIST (NEW)",
"5. COM.LIST (ERR3)", or "6. MNT77LIST" is displayed on the LCD. "ENTER NO. & SET"
is displayed on the LCD.
(3) Enter the telephone number of the receiving machine, and press the [SET] button again.
(4) "Accepted" is displayed for two seconds, and the machine starts dialing to transfer the
data.
Note:
• Be sure to enter the telephone number using the numerical buttons. One-touch dialing
is not allowed in this procedure.
• No station ID will be attached to the data which is transferred. Instead, a cover page
and end page as shown on the next page will be automatically attached.
4-23
Confidential