Brother DCP-1510 Service Manual page 109

(4) Remove the four taptite bind B M3x10 screws.
Assembling Note:
• When removing the document cover, the spring could come off by removing the screw. When
reassembling the document cover, make sure that the spring is assembled.
(5) Release the hook tray and the three hooks to remove the document cover from the lower
document chute ASSY.
Lower document chute ASSY
Document cover
(6) Remove the taptite bind B M3x10 screw.
(7) Lift and pull the front side of the reinforcing plate to pull out it from the hole.
(8) Peel it with the document sponge to the left.
Document sponge
Taptite bind B M3x10
Hook
Hooks
Hook tray
Fig. 2-13
Reinforcing plate
Fig. 2-14
2-19
Taptite bind B M3x10
Taptite bind B
M3x10
Spring
Hole
Confidential