Stanley SCD2 Manual page 6

ENGLISH
LABELS ON TOOL
The label on your tool may include the following symbols:
W ........Watts
Read
Instructions
Manual
min .....minutes
Use Eye
.....Alternating
Protection
Use Ear
.....Direct
Protection
Current
V ........ Volts
n .......No-Load
0
Speed
A ........Amperes
......Class II
Construction
Hz .......Hertz
POSITION OF DATE CODE
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example：
2015
Year of manufacturing
Important Safety Instructions for All Battery
Chargers
SAVE THESE INSTRUCTIONS: This manual contains
important safety and operating instruc tions for the SC201
battery chargers.
• Before using charger, read all instructions and cautionary
markings on charger, battery pack, and product using
battery pack.
WARNING: Shock hazard. Do not allow any
liquid to get inside charger. Electric shock may
result.
CAUTION: Burn hazard. To reduce the risk
of injury, charge only STANLEY rechargeable
batteries. Other types of batteries may burst
causing personal injury and damage.
CAUTION: Children should be supervised to
ensure that they do not play with the appliance.
NOTICE: Under certain conditions, with the
charger plugged in to the power supply, the
charger can be shorted by foreign material.
Foreign materials of a conductive nature such
as, but not limited to, grinding dust, metal chips,
steel wool, aluminum foil, or any buildup of
metallic particles should be kept away from
charger cavities. Always unplug the charger
from the power supply when there is no battery
pack in the cavity. Unplug charger before
attempting to clean.
• DO NOT attempt to charge the battery pack with any
chargers other than the ones in this manual. The
6
....Earthing
Terminal
....Safety Alert
Symbol
Current
.../min.. Revolutions
or Reciprocation per
minute
....The charger is
intended for
indoor use only.
XX JN
charger and battery pack are specifically designed to work
together.
• These chargers are not intended for any uses other
than charging STANLEY rechargeable batteries. Any
other uses may result in risk of fire, electric shock or
electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting
charger. This will reduce risk of damage to electric plug
and cord.
• Make sure that cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
• Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result in
risk of fire, electric shock, or electrocution.
• Do not place any object on top of charger or place
the charger on a soft surface that might block the
ventilation slots and result in excessive internal heat.
Place the charger in a position away from any heat source.
The charger is ventilated through slots in the top and the
bottom of the housing.
• Do not operate charger with damaged cord or plug —
have them replaced immediately.
• Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way. Take
it to an authorised service centre.
• Do not disassemble charger; take it to an authorised
service centre when service or repair is required.
Incorrect reassembly may result in a risk of electric shock,
electrocution or fire.
• In case of damaged power supply cord the supply cord
must be replaced immediately by the manufacturer, its
service agent or similar qualified person to prevent any
hazard.
• Disconnect the charger from the outlet before
attempting any cleaning. This will reduce the risk of
electric shock. Removing the battery pack will not reduce
this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard
household electrical power. Do not attempt to use it
on any other voltage. This does not apply to the vehicular
charger.
SAVE THESE INSTRUCTIONS
Chargers
The SC201/ SC202 accept 18V batteries.