Antique Brick Kit - Jøtul GZ 550 DV II Acadia Installation And Operation Instructions Manual

Jøtul GZ 550 DV II
Brick Panel Assembly
Install the optional 155805 Brick Panels before
placing the Logset. Place the panels in position in
the order as numbered in fig. 37. No fasteners or
tools are required.
Upper Rear Panel,
Left Side
1
Panel,
220997
Lower Rear Panel,
Figure 37. Panel installation order.
Open the lower control panel and locate
f i r e - p a r t s . c o m
the two frame latches under the firebox floor. See
fig. 38. Pull the latch handle forward to disengage
it from the bottom of the glass frame. You can
then pull the frame out and up off of the three
retainer tabs at the top of the firebox opening. Set
the Glass Frame out of the way.
fastened. Simply lift them out of the firebox.
each side panel on the Burner Skirt and against
the firebox wall. Push the panel forward against
the front lip of the firebox opening. See fig. 39.
that the beveled edge is on top and the mortar
joints align with those on the side panels. Set the
bottom edge on the shelf above the restrictor
adjustment slots at the back of the firebox. The
panel should fit snugly between the two side
panels. See fig. 40.
snug fit. Set the panel up high and then carefully
lower it to seat its lower edge against the top of
the other rear panel. The side panels will hold it in
place.
20
220031
4
Right Side
2
Panel,
3
220996
220030
These parts are not
Set the bottom edge of
Orient the panel so
This will also be a
Pull Frame Latches to
Release Frame
Figure 38. Glass Frame latch locations.
Burner Skirt
Figure 39. Install the Side Panels.
Bevelled Edge
Figure 40. Install Lower Rear Panel.
Side
Panel