Transducer Data (Fcv-1200L Only) - Furuno FCV-1200L Installation Manual

3. Press [ ] to select MONITOR TYPE, and then press [+] to open the dialog box.
PORTRAIT LANDSCAPE
4. Use [+] or [-] to select appropriate monitor type, and then press [+] to close the dialog box.
5. Turn off the power to change picture orientation.

3.3 Transducer Data (FCV-1200L only)

This paragraph provides information necessary for entering transducer data. You enter
transducer data by either transducer model number (for FURUNO transducer, page 3-4) or
specification (page 3-5). The FCV-1200L is programmed for use with the following
non-FURUNO transducers.
Maker Frequency
Simrad 38kHz
Airmar 38kHz
Honda 28kHz
33kHz
36kHz
41kHz
50kHz
55kHz
60kHz
67kHz
100kHz
118kHz
200kHz
400kHz
Suzuki 50kHz
200kHz
CAUTION
Set the transducer model number
properly.
Wrong transducer setting can damage the
transducer and void the warranty.
Transducer Type
38E-9-18S1(2kW)
38E-M42(3kW)
28/55/100(3kW)
36/65/110(3kW)
32/40(3kW)
40/75(3kW)
50/200/400(2kW)
50/3K/3F(3kW)
28/55/100(3kW)
36/65/110(3kW)
40/75(3kW)
28/55/100(3kW)
36/65/110(3kW)
50/200/400(2kW)
50/200/400(2kW)
TGM50/200
TGM50/200
Do not enter transducer data by speci-
fications if model number of transducer
used is programmed in the equipment.
Wrong transducer setting can damage the
transducer and void the warranty.
Remarks
Same as FURUNO 50/200-1T(1kW)
CAUTION
3-3