Display unit for separate type, blackbox type (vertical-type control unit)
1. Dismount the coupling place from the rear of the display unit to separate display unit from
control unit.
2. Pass the signal cable (connects between interface unit and display unit) through the slot in
the hanger and then connect the cable to the display unit.
3. Attach the hanger at the rear of the display unit with four binding screws (M4X10).
Display unit for separate type, blackbox type (horizontal-type control unit)
1. Dismount the coupling place from the rear of the display unit to separate display unit from
control unit.
2. Attach the hanger at the rear of the display unit with four binding screws (M4X10).
Signal Cable
Figure 1-5 Monitor unit, rear view
2
1
4
3
Figure 1-6 Hanger, rear view
1
2
4
3
Figure 1-7 Hanger, rear view
HANGER
Slot
Hanger (rear view)
2
1
4
3
Hanger (rear view)
1
2
4
3
1-3