Water Temperature Sensor Setting - Furuno FCV-1200L Installation Manual

3.5 Water Temperature Sensor Setting

If a water temperature sensor is connected set up as follows:
1. Turn on the power and turn the [FUNCTION] switch to the MENU position.
2. Press [ ] and [+] to select SYSTEM at the top of the screen.
3. Press [ ] to select TEMP SETTING, and then press [+] to open that menu.
4. The cursor is selecting TEMP INPUT; press [+] to open the dialog box.
5. Use [+] or [-] to select source of water temperature data, and then press [ ] or [ ] to close
the dialog box.
SONDE: FURUNO Net Sonde FNZ-18 inputs water temperature data.
SENSOR: Water temperature sensor T42 or T80 inputs water temperature data. This is the
default setting.
NMEA: Water temperature data input from navigation equipment.
CIF: Water temperature data input from CIF of Net Sonde.
6. If you chose SONDE or SENSOR at step 5, you may offset water temperature data to
further refine its accuracy. This must be done with the boat in water.
a) Press [ ] to select TEMP ADJUST, and then press [+] to open the dialog box.
b) Watch the water temperature readout on the monitor (if it is not displayed set TEMP
READOUT to ON) and compare it with known value.
3-12
Figure 3-8 TEMP SETTING menu