Furuno FCV-1200L Installation Manual page 28

Separate control unit flush mount kit
Control unit flush mount kit OP06-18 (Code no. 006-556-320)
Separate installation kit OP02-83-1.5 (Code no. 001-413-600)
Separate installation kit OP02-83-5 (Code no. 001-413-610)
Name
Mounting Fixture
Self-tapping Screw
Hex-head Screw
Cable Assy.
1. Make cutout in mounting location referring to page D-5A/D-5B.
2. Fasten mounting fixture to control unit with two hex-head screws.
Figure 1-11 How to flush mount separate type control unit
3. Fasten the control unit to the mounting location with four self-tapping screws.
Separate installation kit
The optional "separate installation kit" or "control unit flush mount kit" is required to install the
monitor and control units separate from one another. Below are the contents of the separate
installation kit. Installation procedure is the same as for the control unit for the blackbox type.
(See next page.) For control unit flush mount kit refer to above section.
Separate installation kit OP06-15-1.5 (with 1.5 m cable, code no. 006-559-140)
Separate installation kit OP06-15-5 (with 5 m cable, code no. 006-559-150)
Name
Cable
Control Unit Bracket
Control Unit Mounting Base
Self-tapping Screw
Hex-head Screw
Cosmetic Plug
1-6
Type
06-021-2101
5×20
M4×12
MJ-A10SPF002-015
MJ-A10SPF002-050
Mounting fixture
Type
MJ-A10SPF0002-015
MJ-A10SPF0002-050
06-021-2112
06-021-2111
5×20
M4×12
DP-687
Code No. Qty
100-279-731 1
000-162-609-10 4
000-162-939-10 2
000-142-878
1
000-131-411
Hex-head screws
Mounting fixture location
changes with unit orientation.
Code
000-142-878
000-131-411
100-281-880
100-279-740
000-162-608-10
000-162-939-10
000-808-417
Remarks
1.5 m
OP02-83 only
5 m
Qty Remarks
1.5 m
1
5 m
1
1
2
4
2